Free independent solar ROI check, Australia-wide Check my home →

Ergon Energy solar export limits for regional Queensland, including single-wire lines

Aussie Solar Info · Checked against the sources listed below, 2026-11-13

If Ergon Energy is the network on your bill in regional Queensland, your solar export limit depends on the type of connection, and on whether your property is on a single-wire line.

Short answer

On Ergon's basic connection, solar can export up to 5kW per phase, or 2kW in total on a single-wire (SWER) line. A dynamic connection lets the limit move with the network, never below 1.5kW while the system stays registered and online. A fixed connection on a single-phase home caps solar and battery inverters at 10kVA combined; a dynamic connection can allow more.

Basic connection

Ergon's basic connection offer for 0 to 30kVA systems allows export of up to 5kW per phase[1]. For homes on a single-wire earth return (SWER) line, with systems of 0 to 20kVA, exports are limited to 2kW in total[1].

Dynamic connection

On a dynamic connection, the export limit changes with network conditions. Once registered and in communication with Ergon, the home can still export 1.5kW when exports have to be reduced, except in a significant emergency[2]. If the internet link drops, the system falls back to a lower fixed limit, typically 1.5kW[2].

Adding a battery

Under a fixed export connection, a single-phase home is limited to 10kVA of inverter capacity in total for solar and battery storage[2]. A dynamic connection allows more combined capacity[2]. That matters if you are adding a battery inverter to an existing solar inverter: on a fixed connection the two together cannot exceed 10kVA.

What this means for a battery

On a 2kW SWER limit, a sunny afternoon's surplus has nowhere to go but a battery. Queensland has no solar export charge for homes until 2030 (see why), but this site's calculator uses about 2.5c a unit for exports against about 28c for power you buy[3], so storing beats exporting even without a limit.

Get your own numbers

Two minutes of questions gets you your system size, what it should cost after rebates in your state, and what it saves, built on your roof and your usage. No installer sees anything unless you ask.

Run my numbers, free

No installer buys placement or ranking here, and nothing reaches an installer unless you ask.

Common questions

What is Ergon's solar export limit?

Up to 5kW per phase on a basic connection, or 2kW in total on a single-wire (SWER) line for systems up to 20kVA.

What is a dynamic connection on Ergon's network?

An export limit that moves with network conditions, with a 1.5kW floor while the system stays registered and online.

How much inverter capacity can I have on a single-phase Ergon connection?

10kVA in total for solar and battery inverters on a fixed export connection. A dynamic connection allows more.

Sources

  1. Ergon Energy, Basic connection service model standing offer, 0-30kVA. Read 2026-11-13. (read through a search engine's copy of the page)
  2. Ergon Energy, About Dynamic Connections. Read 2026-11-13. (read through a search engine's copy of the page)
  3. Aussie Solar Info calculator (how it works), installed battery ranges and rebates as of 2026-11-13.