Independent commercial solar advice, assessed case by case. Commercial solar, assessed case by case. Email Olly →
Commercial solar

Ausgrid business solar: the connection options for 30 to 200kVA

Aussie Solar Info · Checked against the sources listed below, 2026-11-15

If your business is on Ausgrid's network, the size of the inverter decides which connection path you take, and one choice can cut the cost of getting approved.

Short answer

On Ausgrid's network, sites with more than 30kVA and up to 200kVA of inverter capacity can choose to limit exports to 30kW or less for a lower application fee. Above 30kW, AS/NZS 4777.1 requires central protection. Ausgrid's connection standard for these systems is NS194.

The lower-fee option

Ausgrid says sites with more than 30kVA up to 200kVA of inverter capacity can choose to limit exports to 30kW or less for a lower application fee[1]. For a business that uses most of its solar on site during the day, a 30kW export cap may cost little in lost exports and save time and money on approval.

Protection

Ausgrid notes that AS/NZS 4777.1:2024 still requires some installations over 30kW to have interface protection[1]. Its standard for embedded generation connections is NS194[2].

When the export cap is a bad trade

If the site is closed on weekends or most of the summer daylight output exceeds the load, a 30kW cap throws away more. That is exactly what interval data shows. See what to send for an assessment.

Get your business site assessed, by email

Commercial solar depends on your roof, your tariff, your load profile and your network, so every site is looked at individually. There is no online calculator for this, on purpose.

Email Olly about your business site

Or email olly@aussiesolarinfo.com with the subject "Commercial solar enquiry".

No installer pays to appear on this site. Nothing reaches an installer unless you ask.

Common questions

What is Ausgrid's option for 30 to 200kVA solar?

Sites from 30 to 200kVA of inverter capacity can limit exports to 30kW or less for a lower application fee.

Does Ausgrid require central protection for business solar?

AS/NZS 4777.1:2024 requires some installations over 30kW to have interface protection; Ausgrid's standard is NS194.

Sources

  1. Ausgrid, Information for solar installers. Read 2026-11-15. (read through a search engine's copy of the page)
  2. Ausgrid, Standard NS194. Read 2026-11-15. (read through a search engine's copy of the page)