Free independent solar ROI check, Australia-wide Check my home →

Queensland's emergency backstop: what it is, who needs one, and whether it has ever been used

Aussie Solar Info · Checked against the sources listed below, 2026-11-13

If you are installing 10kVA or more of solar in Queensland, your installer will fit a small device that lets the network switch your solar off in an emergency. Here is what it is, and why it is less worrying than it sounds.

Short answer

Queensland's emergency backstop applies to new, replacement and upgraded systems with 10kVA or more of inverter capacity on Energex and Ergon's low-voltage networks, from 6 February 2023. A generation signalling device lets the network stop solar output as a last resort, at the direction of the market operator. Energex says it has never been activated in Queensland, and the device returns the inverter to normal after 4 hours without a signal.

Who needs it

The backstop covers new, replacement and upgraded inverter systems with a total inverter capacity of 10kVA or more on the low-voltage network[1]. It applies to connection offers accepted from 6 February 2023[1]. Systems under 10kVA on an initial connection do not have to comply[1].

Energex lists exclusions, including inverters supplied only by a battery (AC-coupled batteries) or EV chargers, and like-for-like warranty replacements[1].

How it works

The generation signalling device is triggered through the network's audio frequency load control system, the same system long used for off-peak hot water[1]. It lets Energex and Ergon stop the output of a system such as rooftop solar[1]. It is only operated at the direction of the Australian Energy Market Operator, as a last resort, and Energex says an emergency backstop has never been activated in Queensland[1].

There is a fail-safe: if the device does not receive the on signal for 4 hours, it returns the inverter to normal operation[2].

What it means for a battery

An inverter supplied only by a battery is excluded[1]. For a hybrid system of 10kVA or more, the backstop is part of the install, and should be on the quote. It is not a reason to size a system below 10kVA if you need the capacity: the device has never been used, and its job is to protect the grid on rare days of very low demand.

Get your own numbers

Two minutes of questions gets you your system size, what it should cost after rebates in your state, and what it saves, built on your roof and your usage. No installer sees anything unless you ask.

Run my numbers, free

No installer buys placement or ranking here, and nothing reaches an installer unless you ask.

Common questions

What is the emergency backstop in Queensland?

A requirement for solar systems of 10kVA or more on Energex and Ergon's networks to have a device that lets the network stop solar output as a last resort, at the direction of the market operator.

Has the emergency backstop ever been used in Queensland?

Energex says it has never been activated in Queensland.

Do batteries need the emergency backstop?

Inverters supplied only by a battery, such as AC-coupled batteries, are excluded.

Sources

  1. Energex, Emergency backstop mechanism. Read 2026-11-13. (read through a search engine's copy of the page, because the site refuses automated reading)
  2. Energex, Queensland emergency backstop generation signalling device: installation and compliance guideline. Read 2026-11-13. (read through a search engine's copy of the page, because the site refuses automated reading)