Free independent solar ROI check, Australia-wide Check my home →

Sungrow inverter fault codes: what they mean and what to do

Aussie Solar Info · Checked against the sources listed below, 2026-11-13

Sungrow inverters show a numbered fault code in the app or on the display. Here is what the common groups mean, from Sungrow's own documents, and what you should and shouldn't do.

Short answer

Sungrow groups its fault codes by cause. Codes 2, 3, 14 and 15 are grid overvoltage: the voltage at your street is too high, which usually clears by itself. Codes 28 and 29 are a PV reverse connection fault, meaning the panel wiring polarity is wrong, which is a job for your installer, not you. Meanings can vary by model and firmware, so check your model's manual.

Grid overvoltage: codes 2, 3, 14 and 15

Sungrow's FAQ groups codes 2, 3, 14 and 15 under grid overvoltage[1]. The grid voltage at your connection is above the inverter's limit, so it stops or reduces exporting until it drops. If it happens often, especially on sunny afternoons, ask your installer to raise it with the network, which can check local voltage.

PV reverse connection: codes 28 and 29

Sungrow lists codes 28 and 29 under PV reverse connection[1]. Sungrow's manuals say that if PV polarity is reversed, the inverter will be in a fault or alarm state and will not operate normally, and warn not to operate it while the DC switch is on[2]. This is a wiring issue: turn nothing off yourself beyond the documented shutdown, and call the installer.

What to do with any code

Next steps

If the system has stopped producing, see the solar not producing checklist. If you have a solar-only Sungrow SG and want a battery, see adding a battery to a Sungrow SG.

Get your own numbers

Two minutes of questions gets you your system size, what it should cost after rebates in your state, and what it saves, built on your roof and your usage. No installer sees anything unless you ask.

Run my numbers, free

No installer buys placement or ranking here, and nothing reaches an installer unless you ask.

Common questions

What does Sungrow fault code 2 mean?

Grid overvoltage. Sungrow groups codes 2, 3, 14 and 15 under it: the grid voltage is above the inverter's limit.

What does Sungrow fault code 28 mean?

A PV reverse connection fault, meaning the panel wiring polarity is wrong. Call your installer.

Should I reset my Sungrow inverter myself?

Only by the documented shutdown and restart. For recurring or wiring-related codes, call your installer.

Sources

  1. Sungrow, All FAQs (installer). Read 2026-11-13. (read through a search engine's copy of the page)
  2. Sungrow, SG2.0RS to SG6.0RS user manual. Read 2026-11-13. (read through a search engine's copy of the page)